GPP-3060/6030 User Manual
144
[FAST]: In order to protect the function switching
device” relay”, it is necessary to wait until the
voltage and current drop to zero under normal
conditions. When FAST is enabled, this factor will
not be considered, but it is easy to damage the
“relay”, so it is recommended to use it with
caution.
:LOAD2:CC ON
Sets CH2 as Load CC mode.
Sets CH1/CH2 as Load CR mode.
:LOAD2:CR ON
Sets CH2 as Load CR mode.
Queries CH1 or CH2 work mode.
6 modes below:
SERies, PARallel, INDEpendent,
CV Load, CC Load, CR Load.
:MODE1?
Queries CH1 work mode.
:LOAD[1|2]: RESistor <NRf>
:LOAD2:RESistor 100
Sets the Load CR level to 100Ω for CH2.