To Next Page

To Previous Page

GPP-3060/6030 User Manual

166

Function

Sets the sequence number for initial execution.

<value>: Integer 0 - 2047

Example

:SEQUence2:STARt 10

Sets the CH2 sequence output to start from the group

11th.

Command

:SEQUence[1|2]:STARt?

Function

Queries the sequence number for initial execution

of the channel sequence output.

Example

:SEQUence2:STARt?

Returns the initial sequence number of CH2

sequence output.

Command

:SEQUence[1|2][:STATe] {ON|OFF}

Function

Enable or disable sequence function.

To enable sequence will change state of channel

output, make sure the changed output state will

Not impact the device connected with power before

enabling. Sequence output is activated only when

both sequence and channel output are enabled. To

modify parameter is Not available when sequence

is being enabled. For multi-channel model, change

the active channel and set parameter of selected

channel. It is Not allowed to enable sequence and

delay simultaneously.

Example

:SEQUence2:STATe ON

Enable sequence output for CH2.

Command

:SEQUence[1|2] [:STATe]?

Function

Queries the state of sequence output . See previous

instruction.

GW Instek GPP-3060 User Manual

Questions and Answers: