GW Instek GPP-3060 - Page 167

REMOTE CONTROL
167
Example
:SEQUence2:STATe?
Queries the CH2 state of sequence output. Returns
to ON or OFF.
Command
:SEQUence:SYNChronize {ON|OFF}
Function
When both CH1 and CH2 are sequence on, turn on
or off the sequence synchronization between them.
Example
:SEQUence:SYNChronize ON
turn on the sequence synchronization of CH1 and
CH2.
Command
:SEQUence[1|2]:TEMPlet:CONSTruct
Function
Sends the command. Instrument builds, based on
the actively selected templet and set the sequence
parameter.
Example
:SEQUence2:TEMPlet:CONSTruct
Set CH2 to build sequence output according to the
selected template and set parameters..
Command
:SEQUence[1|2]:TEMPlet:FALLRate <value>
Function
Sets the falling degree of ExpFall.
Description
<value> Integer from 0 to 10.
Example
:SEQUence2:TEMPlet:FALLR 5
Sets the CH2 falling degree of ExpFall as 5.
Command
:SEQUence[1|2]:TEMPlet:FALLRate?
Function
Queries the falling degree of the active ExpFall.
Example
:SEQUence2:TEMPlet:FALLRate?
Queries the CH2 falling degree of the active
ExpFall. Returns to an integer ranging from 0 to 10.