H3C S5000V3-EI User Manual

86
GE SFP
transceiver
module/cable
Central
wavelength
Connector
Cable
specifications
Modal
bandwidth
(MHz*km)
Max
transmission
distance
0-BIDI
modules in
pairs.
SFP-
GE-L
H70-S
M155
0-BIDI
• TX: 155
nm
• RX:
1490 nm
SFP cable
SFP-STACK-Kit N/A N/A SFP cable N/A 1.5 m (4.92 ft)
Table 29 FE SFP transceiver modules
FE SFP transceiver
module
Central
wavelength
Connector Fiber
Max
transmission
distance
SFP-FE-SX-MM1310-A 1310 nm LC
• 50/125 µm,
multimode
• 62.5/125 µm,
multimode
2 km (1.24 miles)
SFP-FE-LX-SM1310-A 1310 nm LC
9/125 µm, single
mode
15 km (9.32 miles)
SFP-FE-LX-SM1310-D 1310 nm LC
9/125 µm, single
mode
15 km (9.32 miles)
SFP-FE-LH40-SM1310 1310 nm LC
9/125 µm, single
mode
40 km (24.86 miles)
SFP-FE-LH80-SM1550 1550 nm LC
9/125 µm, single
mode
80 km (49.71 miles)
SFP-FE-
LX-SM1
310-BIDI
You must
use these
two
transceiver
modules in
pairs.
• TX: 1310 nm
• RX: 1550 nm
LC
9/125 µm, single
mode
15 km (9.32 miles)
SFP-FE-
LX-SM1
550-BIDI
• TX: 1550 nm
• RX: 1310 nm
LC
NOTE:
•
As a best practice, use H3C transceiver modules and cables for the switch.
•
H3C transceiver modules and cables are subject to change over time. For the most up-to-date list of H3C
transceiver modules and cables, contact your H3C sales representative or technical support engineer.
• For the specifications of H3C transceiver modules and cables, see H3C Transceiver Modules User Guide.
SFP+ port
The S5560S-28S-SI switch, S5560S-52S-SI switch, S5560S-28F-SI switch, S5500V3-SI switch
series, S5130S-SI switch series, and S5130S-LI switch series provide SFP+ ports. To connect SFP+
ports over a long distance, use SFP/SFP+ transceiver modules and optical fibers. To connect SFP+
ports over a short distance, use SFP+ cables. The SFP+ ports on the switch support the following
transceiver modules and cables:

H3C S5000V3-EI Specifications

General

Brand	H3C
Model	S5000V3-EI
Category	Switch
Language	English