6
Installing the switch in a 19-inch rack
Installation methods
Table 3 Installation methods for the S5560-EI switches
Chassis
Installation
methods
Installation requirements Installation procedure
S5560-30C-EI
S5560-34C-EI
S5560-54C-EI
S5560-30F-EI
S5560-30S-EI
S5560-54S-EI
Using front mounting
brackets
Install the front mounting brackets at the
port side, power module side, or the
middle-mounting position.
See "Rack-mounting by
using front mounting
brackets."
S5560-30C-PW
R-EI
S5560-54C-PW
R-EI
Using front mounting
brackets
Install the front mounting brackets at the
middle-mounting position.
See "Rack-mounting by
using front
mounting
brackets."
Using front and rear
mounting brackets
• Install the front mounting brackets
at the port side or power module
side.
• Install the rear mounting brackets
according to the rack depth.
{ If the rack depth is in the range
of 429 to 595 mm (16.89 to
23.43 in), orient the bracket
with the wide flange inside the
rack.
{ If the rack depth is in the range
of 274 to 440 mm (10.79 to
17.32 in) and the distance from
the rear rack posts to the inner
surface of the cabinet door is
longer than 153 mm (6.02 in),
orient the bracket with the wide
flange outside the rack.
See "Rack-mounting by
using front and
rear
mounting brackets
(S5560-30C-PWR-EI,
S5560-54C-PWR-EI,
and S5560-54QS-EI)."
S5560-54QS-EI
Using front mounting
brackets
Install the front mounting brackets at the
power module side or middle-mounting
position.
See "Rack-mounting by
using front mounting
brackets."
Using front and rear
mounting brackets
• Install the front mounting brackets
at the port side or power module
side.
• Install the rear mounting brackets
according to the rack depth.
{ If the rack depth is in the range
of 332 to 496 mm (13.07 to
19.53 in), orient the bracket
with the wide flange inside the
rack.
{ If the rack depth is in the range
See "Rack-mounting by
using front and
rear
mounting brackets
(S5560-30C-PWR-EI,
S5560-54C-PWR-EI,
and S5560-54QS-EI)."
To Next Page
Loading...
Need help?
General