40
Operating Manual
POWER CLAMP
English
Quality Wins.
© 2021/09 Haimer POWER CLAMP
Standard Extension S-chuck .....
Press the and keys simultaneously to jump from
one group to the next.
You can switch between the individu-
al sizes by using the
or keys. The
size that has been set is visible in the display.
Extension
ØA 25 ØI 14 - 16
Pos. #4 B4
Setting the coil Shrinkcode
Type of
Shrink Fit chuck
Size of Shrink Fit chuck
Example 1:
Shrinking in a shrink fit extension (external diameter
25, internal diameter 10) in a standard shrink fit chuck
Group: Standard
Shrinkcode: A6
Size: Ø 25 - 32
Coil position: #8
Example 2:
Shrinking in a milling cutter with shank diameter 10 in
a shrink fit extension with outside diameter 25, inside
diameter 10):
Group: Extension
Shrinkcode: B3
Size: ØA 25, ØI 8-12
Coil position: #3
Automatic function
In most groups of shrink fit chucks the automatic function
is available as well as the size details. If this function is
selected the shrink fit chuck that is used is detected automat-
ically. The software then searches from the parameters of
the group that has been set for the matching ones.
This function is also very helpful in the case of chucks of
unknown origin or for chucks that do not comply to any
standard. You only need to select a group of chucks that re
-
semble the one being used. Such chucks can usually shrink
without any problems by using the automatic function.
Operation
To Next Page