HAIMER Basic - Intended Use; Workplace Equipment

To Next Page

To Previous Page

Operating Manual

POWER CLAMP

English

Quality Wins.

• Always unplug the relevant unit before carrying out any cleaning, maintenance or servicing

work, and the same applies if it will not be used for a longer period.

• Do not allow any liquid to enter the interior of the housing during cleaning. Protect the device

from moisture as it may create an electrical shock hazard.

• Lay out the power cord so that nobody can trip over it or get tangled in it.

• Repairs to the POWER CLAMP shrink ﬁt machine may be performed by specialised per-

sonnel only. Any work done to the electronics of the device is to be performed by elec-

tronics technicians only. The housing is not to be opened by unauthorized personnel.

Attention! Dangerous residual voltages are present in the housing for up to 5 minutes

after switching the unit off.

• Safety mechanisms may not be removed, bypassed or taken out of operation.

• Unauthorised modiﬁcations or changes are not permitted for safety reasons.

1.2 Intended use

The POWER CLAMP shrink ﬁt machine has been designed for changing tools on shrink ﬁt chucks

and is constructed exclusively for this purpose. The device is suitable for shrinking tools having a

diameter from 3 mm to 32 mm.

All the current shrink ﬁt conical chuck sizes can be used due to the chuck adapter system. In ad-

dition, the cooling device adapter system makes it possible to cool chucks of any external shape.

This device is only meant to be used for industrial applications.

Franz Haimer assumes no liability for the utilisation of this product for any application other than

that described in this operating manual. This also eliminates any guarantee claims.

1.3 Workplace equipment

Ensure that your workplace is always orderly and clean. An unorganised workplace increases

hazards.

The device must be positioned of a sufﬁciently stable and level sub-structure. Do not shake or tip

the device during operation.

The device must be protected from moisture and contamination.

In general the obligations on the operating company regarding safe operation speciﬁed in the EC

Directive 2009/104/EC must be complied with by the operating company.

Safety