HAIMER Basic - Water Pump Does Not Start; Setting the Cooling Temperature

To Next Page

To Previous Page

Operating Manual

POWER CLAMP

English

Quality Wins.

6.3.1 Water pump does not start

• Switch off the SPEED COOLER

• Move (rotate) the fan wheel (65) of the motor (64) by

using a screwdriver placed through the cover (63) and

the motor protective cover.

• Remove the screwdriver

• Switch the cooler on

• Check whether the pump motor runs

If it does not start: there is an electrical defect

6.3.2 Setting the cooling temperature

The temperature of the cooling water is set at the factory

to approx. 18 °C. If the relative humidity is high or the

weather conditions are unfavourable the humidity in the

air can condense out on the cooling bodies. The cooling

body "sweats". In this case the temperature must be in-

creased somewhat.

Caution: This work should only be done by a skilled

electrician.

• Disconnect the mains cable

• Remove the cover (63)

• Remove the cover from the switchbox (66)

• Turn the temperature regulator by approx. 15° clockwise.

The cooling temperature is reduced if the temperature

regulator is turned counter-clockwise.

• Close the switchbox (66).

• Replace the cover (63)

Repeat the process if the cooling bodies still "sweat".

Correcting Faults