handi quilter Infinity 26 - Threading the Machine

HQ Innity User Manual | 35
1 . Place thread cone onto spool post ① on the thread tray, insert the thread through the thread-mast
eyelet ② from back to front, connuing to the thread guide ③.
2 . Connue to the three-hole thread guide ④. Wrap all three holes from back to front, being careful
not to cross threads. This is recommended for most threads. However, some very delicate threads
or metallic threads may require less tension. If you are having problems with thread breaking, try
threading only one or two holes of thread guide 4.
3. The thread connues down to the tension assembly ⑤.
 IMPORTANT: The thread must be ossed up between the two tension discs. If the thread is not
rmly in place between the two tension discs, the thread will lay on top of the tension discs (no
tension) and thread looping on the boom of the quilt can occur.
4 . Aer the thread is in place, be sure that the thread catches on the take up spring and then pull it down
under the srrup thread guide ⑥.
5 . Bring the thread up and through the take-up lever ⑦ from back to front, and then to the pigtail thread
guide ⑧, and thread through the needle bar thread guide hole ⑨ .
6. Make sure the thread is following the groove down the front of the needle and insert thread through
the eye of the needle ⑩ from front to back. While pulling thread through the eye of the needle be
careful that the thread does not twist around the needle.