handi quilter Infinity 26 - Install the Laser Stylus

2 4 | www.HandiQuilter.com
To use rulers and templates with your quilng machine
 ONLINE: For more informaon about using rulers and templates, watch the video Using Rulers and
Templates at: hp://www.handiquilter.com/videos/hq-innity/220/.
U CAUTION: Use only one-quarter inch thick rulers with your machine. Do not use rotary-cung
rulers as they are too thin and can easily slip under the hopping foot. Always use a ruler base or
extended table to stabilize the ruler.
Keep the ruler at and quilt only where ruler is held securely. Avoid losing control by walking your hand
along the ruler or stopping and reposioning your hand and the ruler.
• Apply gentle three-point pressure to the ruler, as follows.
1 . Press the ruler against any side of the hopping foot.
2 . Press machine against ruler.
3. Press ruler against ruler base with only as much force as is necessary to keep the ruler from
slipping. Too much pressure will keep the machine from moving.
The quilng line is approximately a quarter inch away from the ruler edge for most machines. The markings
on all Handi Quilter rulers take this into consideraon.
 NOTE: Set the machine to stop in the needle-down posion to keep the machine from moving while
making adjustments with the ruler.
Install the Laser Stylus
The laser light (for use with paper pantographs) is installed on a mounng post that is aached to the
accessory track along the right side of the machine.
To install the mounng post and laser stylus
 ONLINE: For more informaon about installing the laser mounng post and laser stylus, watch the
v i d e o Installing the Laser Stylus at: hp://www.handiquilter.com/videos/hq-innity/221/.
1 . Locate the laser bracket with mounng post, the laser stylus, and the 5mm hex wrench.
2 . Insert the T-nut on the laser bracket into the
Handi Accessory Rail and slide into the rail.