62 | www.HandiQuilter.com
The op ons for customizing the star and diamond bu ons are:
Op on Ac on Performed
None The bu on will not perform a func on.
Start/Stop Starts or stops s tching
Needle Up/Down Performs a half s tch by cycling the needle up or down
I n c r e as e Increases s tching speed
Decrease Decreases s tching speed
Thread Cut Cuts the bobbin thread
I n c r e as e T e n s i o n Increases ( ghtens) the top tension
Decrease Tension Decreases (loosens) the top tension
Camera (Front Display) Displays video from the camera on the front display
Camera (Back Display) Displays video from the camera on the back display
Tie O Performs a e-o s tch
 IMPORTANT: If you use HQ Pro-S tcher, it will override your se ngs for the star and diamond
handlebar bu ons for selected HQ Pro-S tcher func ons. For more informa on about using
HQ Pro-S tcher with the In nity, refer to the HQ Pro-S tcher user manual.
L as e r L i g h t s
The In nity comes equipped with two laser lights. One is by the needle to
precisely show where the needle will enter the quilt. The other is the laser
stylus that is used at the back of the machine for tracing pantographs.
Turn on or o one or both of the lasers with the Laser se ngs.
For more informa on about installing the laser stylus, see Install the Laser
Light Stylus i n t h e Installa on and Setup sec on of this manual.
ONLINE: For more informa on about quil ng with pantographs, watch the video
Using Pantographs at: h p://www.handiquilter.com/videos/hq-in nity/240/.
To turn the lasers on or o
• T o u c h t h e Se ngs icon in the toolbar. Then touch the Lasers bu on.
Touch the light bu on to turn the laser on or o .
To Next Page
Loading...
