HAO INSTECH HY8200 Series User Manual

HY8200 User’s Manual
47
Parameter
MIN~MAX |MINimum|MAXimum
Unit
mS
Reset Value
0.1
For Example
DYN: HIGH:DWELL 10 or DYN:TB:DWELL 10
// Set the duration of the load current (IB) to 10mS in dynamic mode
Query Syntax
[SOURce]:DYNamic: HIGH:DWELl?
// Query the duration of the load current (IB) in dynamic mode
Query Syntax
[SOURce]:DYNamic:TB:DWELl?
// Query the duration of the load current (IB) in dynamic mode
Return Parameter
<NR2>
7.6.26 [SOURce]:DYNamic:SLEW
[SOURce]:DYNamic:SLEW Set the current slop for the dynamic mode
Command Syntax
[SOURce]:DYNamic:SLEW<NRF+>
Parameter
MIN~MAX |MINimum|MAXimum
Unit
A/us
Reset Value
MAX
For Example
DYN:SLEW 1 // Set the current slop to 1 A/us for the dynamic mode
DYN:SLEW 0.3,0.5 //Set the rising current slop to 0.3 A/us for dynamic mode
Set the falling current slop to 0.5 A/us for dynamic mode
Query Syntax
[SOURce]:DYNamic:SLEW?
// Query the current slop of the dynamic mode
Return Parameter
<NR2>
7.6.27 [SOURce]:DYNamic:SLEW:RISE
[SOURce]:DYNamic:SLEW:RISE Set the rising rate for the current in dynamic mode
Command Syntax
[SOURce]:DYNamic:SLEW:RISE <NRF+>
Parameter
MIN~MAX |MINimum|MAXimum
Unit
A/us
Reset Value
MAX
For Example
DYN:SLEW:RISE 1
// Set the rising rate of the current to 1 A/us in dynamic mode
Query Syntax
[SOURce]:DYNamic:SLEW:RISE?
// Query the rising rate of the current in dynamic mode
Return Parameter
<NR2>
7.6.28 [SOURce]:DYNamic:SLEW:FALL
[SOURce]:DYNamic:SLEW:FALL Set the falling rate for the current in dynamic mode
Command Syntax
[SOURce]:DYNamic:SLEW:FALL <NRF+>
Parameter
MIN~MAX |MINimum|MAXimum
Unit
A/us
Reset Value
MAX
For Example
DYN:SLEW:FALL 1
// Set the falling rate of the current to1 A/us in dynamic mode

HAO INSTECH HY8200 Series Specifications

General

Brand	HAO INSTECH
Model	HY8200 Series
Category	Measuring Instruments
Language	English