HAO INSTECH HY8200 Series User Manual

HY8200 User’s Manual
52
Parameter
1~16,0~40,200~99999 ,| MINimum | MAXimum OFF|OF
CURRent | VOLTage | RESistance | POWer | OPEN | SHORT
For Example
LIST:PARAMeter:ITEM 0,CURR,2.0,1000,OFF,1.0, 2.0
// Set the serial number to 1, mode to CC, constant value to 2.0, timing
to1000ms, check is off, the lower limit is 1.0, the upper limit is 2.0 for the
list mode
Query Syntax
[SOURce]:LIST:PARAMeter:ITEM?
// Query each parameter of list in list mode
Return Parameter
<>
7.6.47 [SOURce]: LIST:TEST:RESUlts?
[SOURce]:LIST:TEST:RESUlts? Return the test result of list mode
Command Syntax
[SOURce]: LIST:TEST:RESUlts?
Parameter
1~16 or no parameter (return all test result)
For Example
LIST:TEST:RESUlts? 1
or
LIST:TEST:RESUlts?
Query Syntax
[SOURce]: LIST:TEST:RESUlts?
// Query each parameter of the list in the list mode
Return Result
0,CURR,1.00,OFF,0.00,0.00,PASS;1,CURR,3.00,OFF,0.00,0.00,PASS;2,
CURR,4.00,OFF,0.00,0.00,PASS;3,VOLT,5.00,OFF,0.00,0.00,PASS;
7.6.48 [SOURce]: LIST:TEST[:STATe]?
[SOURce]:LIST:TEST[:STATe]? Return the test state of list mode
Command Syntax
[SOURce]: LIST:TEST[:STATe]?
Parameter
1~16 or no parameter
For Example
LIST:TEST? 1 or LIST:TEST?
Query Syntax
[SOURce]: LIST:TEST? // Query the test state of list mode
Return Result
PASS
7.7 CHANnel[:LOAD] Channel Control Subsystem(only for dual-channel)
CHANnel[:LOAD] Set the channel to receive the insturction
Command Syntax
CHANnel[:LOAD]
Parameter
1~2 or CH1、CH2 、ALL (channel)
For Example
CHANnel 1 or CHANnel CH2
Query Syntax
CHANnel[:LOAD]?
// Query the channel that receive the insturction
Return Result
2
7.7.1 CHANnel:SHORtcut[:COMMand]

HAO INSTECH HY8200 Series Specifications

General

Brand	HAO INSTECH
Model	HY8200 Series
Category	Measuring Instruments
Language	English