3 - Description
3.9
General keystrokes, Example: Tank contents
Press # to enter [1.2 TANK CONTENTS].
To clear value, move cursor to digit and press | .
To move the cursor press ¶ or § .
Press ¿ or ª to set the desired value, or key in value on numeric keys.
Press # to confirm. gallon
Press ~ to exit.
Keystroke menu tree
The first steps to choose a menu are shown below.
Press # to proceed into the menu. See the relevant section in the book.
Press ~ and hold to exit the menu system.
Extended menu
This menu has been set up by your HARDI® Service center. It contains parameters that are typically set only once, normally
before the Controller is used.
μ
ATTENTION! Unless instructed, do not tamper with the settings and values in these menus. Doing so may void
warranty.
1.2 Tank cont.
1200.00
gallon
To change displayed tank contents.
Use arrow or numeric keys to set.
To Next Page
Loading...
