8 - Menu 4 Toolbox
8.2
Menu 4.2 Service intervals
Menu and intervals
Service intervals and a nozzle check are programmed into the Controller. This makes it easier for the operator to remember
the service intervals.
From the factory, the Controller is set up with a nozzle check and three service reminders.
Entering the above menus will display the hours remaining until next service. The importer or dealer may have added
Interval D. If no interval is set, [D Not defined] is shown.
Press # to register service or control, if displayed when switched on. The warning ¢ will remain present until the service
interval is reset.
Menu & interval Hours Action
[4.2.1 Check filters] 10 See sprayer instruction book, Maintenance.
[4.2.2 Grease boom] 50 See sprayer instruction book, Maintenance.
[4.2.3 Grease track and center] 250 See sprayer instruction book, Maintenance.
[4.2.4 Miscellaneous service] - Not defined from factory.
[4.2.5 Check nozzles] 50 Check flow rate. Change nozzles if more than 10% of rated flow.
To Next Page
Loading...
Need help?
General
