9 - Menu 5 Logbook
9.2
Menu 5.2 Data dump
How to dump data
Enables data dump to an office printer. This could be done, for example, by using the Hyper Terminal function in Microsoft
Windows. Note the Hyper Terminal has to be activated and a communication cable (ref. no. 72271600) and 12 volt power
supply to the Controller and Spray Box is needed.
The Hyper Terminal baud rate should be set at one of the following before transmitting data:
19200 baud
9600 baud (HC 6500 default)
4800 baud
2400 baud
1200 baud
If only the display unit is to be removed from the tractor, a 12 Volt power supply cable (ref. no. 72244500) is necessary.
The following can be printed to an office printer.
[5.2.1 Data dump of raw data]
[5.2.2 Hyperterminal service report] Permits data to be set up with a column header.
To Next Page
Loading...
