6 - Menu 2 Setup
6.6
Menu 2.4 Set clock
How to set clock
If the Controller prompts for date and time, [Set clock to enable register]:
This must be done before the Controller is put into operation for the first time, otherwise no start and stop time will be
recorded in the registers.
μ
ATTENTION! If no prompt, the dealer may already have done this.
Press #.
Press ª to menu [2 Setup].
Press #.
Press ª to menu [2.4 Set clock].
Press # to enter first submenu, menu [2.4.1 Time format (12 or 24 hour)].
By using ¿ or ª you can choose between:
Menu [2.4.1.1 12 hour format]
Menu [2.4.1.2 24 hour format]
Press # and return to previous menu by pressing ~.
Press ª to menu [2.4.2 Set time]
Press # and set minutes and hours with ¿ or ª and ¶ or §. Alternatively use the numeric keys.
Press # to confirm.
Press ª to menu [2.4.3 Set date and month]
Press # and set day and month with ¿ or ª and ¶ or §. Alternatively use the numeric keys.
Press # to confirm.
Press ª to menu [2.4.4 Set year]
Press # and set year with ¿ or ª and ¶ or §. Alternatively use the numeric keys.
Press # to confirm.
Press ~ and hold to exit menu system.
To Next Page
Loading...
