8 - Menu 4 Toolbox
8.8
Menu 4.8 Computer CAN status
Menu 4.8.X Computer CAN status
In this menu you can see if there is communication between the units, Controller, Jobcom and Track. See part “Emergency
operation”.
Following submenus are available:
[4.8.1 Operating status all computer] Show operating status details in case of faults.
[4.8.2 Software versions all computer] Show software versions details in case of faults.
[4.8.3 Hardware versions all computer] Show hardware versions details in case of faults.
[4.8.4 Work status Terminal HC 6500] Show faults occurred since power-up. Press | key to reset counters.
[4.8.5 Work status JobCom HC 6100] Show faults occurred since power-up. Press | key to reset counters.
[4.8.6 Work status Grip HC 6300] Show faults occurred since power-up. Press | key to reset counters.
[4.8.7 Work status SetBox HC 6400] Show faults occurred since power-up. Press | key to reset counters.
[4.8.8 Work status FluidBox HC 6200] Not used in North America. Press | key to reset counters.
To Next Page
Loading...
Need help?
General
