8 - Menu 4 Toolbox
8.5
Menu 4.5 Test
How to test
All readouts for the transducers are in accumulated counts, i.e. one signal gives one count, except for the optional (analog)
transducer that is read in milli-ampere.
1. Go to menu [4.5 Test].
2. Choose the item to be tested and open the menu.
3. Activate sensor and see if the signal is detected.
[4.5.1 Flow Speed Optional sensors] Activate function to monitor sensor (e.g. drive forwards, start flow).
[4.5.2 Active keys] Push key to see if a count is registered. If yes, the key or switch function is OK.
[4.5.3 PrimeFlow test] Not used in North America.
[4.5.4 Input test] See computer readings of sensors. Frequency, switch, analog inputs.
[4.5.5 Valve test] Self test.
[4.5.6 Reset PrimeFlow counters] Not used in North America.
To Next Page
Loading...
Need help?
General
