MM-013994-001, Rev. J
36
Function disabled (e.g., function invalid in current context).
9.10 KEYPAD FUNCTION COMMANDS (P7370 ONLY)
To perform a command from the keypad, use the keypad commands in Table 9-6.
Table 9-6: Keypad Function Commands
COMMANDS FUNCTION
Log-off command: *0## (logs the user off the system). See Section 9.4 for additional information.
*1
Log-in command: *1<User ID> # <Password> ## (required for encryption). See Section 9.1.3 for
Status Message: *2 <0...9> #.
*4
Enter Scene of Incident Mode (SOI) on specified channel and band: *4#<Chan>#<Band>#
where Chan is the channel number that is being used as a SOI repeater and band is the number
assigned to each frequency band. For example, if Channel 25 800 MHz (band 0) is being used for
SOI, then enter *4#25#0#.
RTT Message: *5 <0...9> #.
*7
Initiate Selective Alert command: *7<Target ID>#[Choose Message]#. See Section 9.26 for
Radio-to-Radio Call command: *8<Selective call number>#(PTT to dial).
*9
Public Switched Telephone Network (PSTN) Call command: *9 <telephone number>#(PTT to
dial) See Section 9.27 for additional information.
*32
Begin Manual Encryption command: *32<Pre-determined Encryption Key>#
1-16 digit encryption key for 128 bit encryption; 17-32 digit encryption key for 256 bit encryption.
End Manual Encryption command: *33#
Initiate XCOV Mode: Extended coverage for individual users.
Initiate XCOV-TG Mode: Extended coverage for Talk Groups.
Initiate XCOV-PROF Mode command: *63#.
Exit XCOV or XCOV-TG Mode: Returns to the Network mode.
To Next Page
Loading...
Need help?
General
