To Next Page

To Previous Page

MM-013994-001, Rev. J

Stealth Mode can also be disabled by using the Stealth Menu.

P7350 only: To re-enable all lighting, side tones and exit Stealth Mode, press the or buttons or

the button. The radio returns to the Dwell Display.

The display lights, indicator lights, and side tones are re-enabled. The stealth mode icon disappears.

9.19 ADJUSTING SIDE TONE AUDIO LEVEL

The radio sounds confirming tones called “side tones” when its buttons are pressed. Most users find this

audible confirmation helpful when navigating the menus. Side tone audio level can be adjusted or turned

completely off using the “Side Menu” or the Quick Key combination #4.

Quick Key combination #4 turns off the backlight in addition to the side tones. Unlike

Stealth Mode, alert tones can still be heard.

For covert operations, it may be necessary to turn off side tones. For safety’s sake, turning off the radio

during covert operations is not recommended.

If the radio is operating properly but side tones are not heard when the menu buttons are pressed, the side

tones are probably turned off. To turn them back on, access the “Side Tone” menu and select a setting

other than “off.”

Use the following procedure set side tone level:

1. Press the or buttons to cycle through the menu until Side Menu is displayed.

2. Press or to change to the desired level (Off, Low, Medium, and High). To turn side tones off

completely, use the “Off” setting.

9.20 CHANGE OPERATING MODE

9.20.1 From OTP to ECP Mode

Method 1 (Quick Key, P7370 only):

1. Press 1#. If ECP is not loaded in the radio, the radio displays “No App.”

Method 2:

To change from OTP operation to ECP operation using the menu, perform the following steps:

1. Press the or

buttons to cycle through the menu until “App Mode” is displayed.

2. Press or to select the desired operation mode.

3. Press and use or to select Y or N.

4. Press to make selection and return to the dwell display.

5. “Restart Please Wait” appears in the display as the radio switches modes.

Method 3:

If configured, turn the A/B Switch to the A or B position.

NOTE

Harris P7300 SERIES User Manual

Questions and Answers: