Harris P7300 SERIES User Manual

MM-013994-001, Rev. J
83
P7370 Model Radio
1. Follow the procedure in Section 10.25.2 to establish a connection to the telephone system or consult
the system administrator for the procedure to access a dial tone on the trunked or conventional
system.
2. Overdial numbers are transmitted using one of the following methods:
METHOD 1:
1.
Enter the overdial selection mode by pressing the button.
2.
Use the or buttons to scroll through the list of stored numbers.
is displayed. Press the PTT to send the overdial sequence once. If the
number needs to be transmitted again it must be selected or entered again
(this prevents unwanted numbers from being sent the next time the PTT
button is pressed during the call).
Overdial select/entry mode remains active until the call is dropped, cleared, or
is pressed. The overdial select/entry mode can be re-
entered if the call is
still active by pressing .
METHOD 2:
(P7370 model radios only)
1.
Enter the overdial selection mode by pressing the button.
2.
Press and hold the PTT
button while entering the overdial number
sequence from the keypad. This method sends DTMF tones during
individual, telephone interconnect, trunked group, or conventional
channel
calls. Press the PTT to send the overdial sequence once. If the number
needs to be transmitted again it must be selected or entered again (this
prevents unwanted numbers from being sent the next time the PTT button
is pressed during the call). A
nytime the PTT button is pressed and held,
the keypad is enabled for DTMF entry.
Overdial select/entry mode remains active until the call is dropped, cleared, or
is pressed. The overdial select/entry mode can be re-
entered if the call is
still active by pressing .
This overdial select/entry mode remains active until dropped, cleared, or is pressed. The overdial
select/entry mode can be re-entered if the call is still active by pressing the button.
10.26 PRE-STORING INDIVIDUAL AND TELEPHONE INTERCONNECT
CALLS FROM THE KEYPAD
Individual Call ID numbers, telephone numbers, and other number sequences for overdialing are stored in
the special calls lists when programming the radio. The first ten entry locations of these lists can be
changed by the radio operator. The keypad is used when adding, changing, and storing numbers in these
entry locations.
Use the following procedure to store a number in one of the first ten entries of a special call list:
1. Press the or button to enter the individual call list or the phone call list. is displayed.
2. Scroll through the list using the or keys until one of the first ten entries is reached. NO
ENTRY is displayed if the location is empty.
3. Enter the desired number. If necessary, a pause can be entered by pressing and holding 0-9, , or
until an underscore appears in the display (telephone interconnect only). The individual call list
entries will accept up to 5 digits. The phone call list entries accept a combination of up to 31 digits
and pauses.

Harris P7300 SERIES Specifications

General

Brand	Harris
Model	P7300 SERIES
Category	Portable Radio
Language	English