MM-013994-001, Rev. J
45
Table 8-9 lists and defines the messages that are displayed by the radio during a selective call.
Table 8-9: Status of Selective Call
Peer is involved in another selective/PSTN call.
Selective/PSTN call was terminated for unknown reason.
Selective/PSTN call cannot continue because of an unspecified network error.
Peer or this user declined request to establish selective/PSTN call.
Peer cannot be reached for selective/PSTN call.
Calling peer (i.e., for selective or PSTN calls).
Establishing selective/PSTN call with peer.
Peer or this user terminated selective/PSTN call.
Selective/PSTN call limited to 10 minutes.
Selective/PSTN call has 10 seconds remaining before limit is reached (shown for 5 seconds).
Selective call is active.
9.25.2 Selective Call Using Speed Dial
Speed dial numbers are defined and provisioned by the OpenSky network administrator and
cannot be manually entered into the radio by the user. Contact the administrator if changes
to the speed dial list are required.
1. Scroll through the Menu options using the or button until Speed Dial appears in the
second line of the display. Using the or keys, scroll through the pre-programmed speed-dial
numbers until the desired number appears in the display and press the PTT button.
OR
2. Press and hold a key associated with a given number for more than three seconds. For example, press
and hold the to open the Speed Dial Menu and display the number assigned to that key in the
speed dial list. Press the PTT button.
3. A ring tone is sounded.
If the other user accepts the call, the called user’s alias will appear in initiating caller’s display. The two
are now in a unit-to-unit call until one ends the call, or the call is terminated due to an initiated
emergency.
If the called radio is involved in another selective call, BUSY will appear on the second line of the display.
Unavailable is displayed when the call has not been answered after a 1 minute timeout or when the
other party is not registered on the network.
9.25.3 Accepting a Selective Call
1. The radio will ring (like a telephone), indicating you are receiving a Selective Call.
2. Press the , or the or
buttons to accept the incoming Selective Call.
3. CONNECT will appear in the display, followed by Lim 10 Min., SEL CALL, and the alias of the
caller appear in the display once the call is established.
To Next Page
Loading...
Need help?
General
