MM-013994-001, Rev. J
76
group/channel is assigned as Priority 1 or Priority 2, the previously assigned group/channel will
change to non-priority scanning. One of the following messages may be momentarily displayed:
The radio is not programmed to scan.
group/channel has been pre-
programmed into the radio. A new Priority 1
group cannot be selected.
A fixed scan list has been pre
-
programmed into the radio. It is not possible to change
the list without reprogramming the radio.
To quickly view multiple group scan status, press either or the
slowly rotate the group knob. Each group/channel status will appear on the display.
10.20.3 Deleting Groups from a Scan List
P7350 Model Radio
1. With scan operation turned OFF, select the desired group/channel to delete from the selected scan list.
2. Press . The current status of the group/channel is displayed for a time-out period.
3. While the current status is displayed, press until the group/channel from the scan list is "blank."
The sequence is "blank," , , , "blank." Any group that is not in a scan list will show a "blank" for
the time-out period when it is the selected channel.
P7370 Model Radio
1. With scan operation turned OFF, select the desired group/channel to delete from the selected scan list.
2. Press . The current status of the group/channel is displayed for a time-out period.
3. While the status is displayed, press
to delete the group/channel from the scan list. , , or
turns OFF. Any group/channel that is not in a scan list will show a "blank" for the time out period
when it is the selected group/channel.
10.20.4 Nuisance Delete
A group/channel can also be deleted from the scan list, if it is not the currently selected group/channel, by
pressing the key (P7350 model) or the key (P7370 model) during scan operation while the
radio is displaying the unwanted group/channel. The group/channel will be deleted from the scan list in
the same manner as if done using the steps above. Deletions done in this manner will not remain deleted if
the radio is powered OFF and then powered ON.
10.21 SYSTEM SCAN (EDACS AND P25 TRUNKED)
The radio can be programmed using Radio Personality Manager (RPM) with the following System Scan
features. These features are automatically enabled when the radio is powered ON. A key or menu option
is also defined to allow the System Scan features to be toggled during radio operation. The System Scan
state will be maintained through system changes but will default to ON when the radio is powered ON.
To Next Page
Loading...
Need help?
General
