MM-013994-001, Rev. J
75
10.20.2 Add Groups and Channels to a Scan List
P7350 Model Radio
1. Scan must be OFF to add groups/channels to the scan list. If the Scan icon is ON, press the
key to turn Scan OFF.
2. Select the desired group/channel using the System/Group/Channel control knob and/or the or
keys. If the selected group/channel is currently on the list, pressing will display on line
three.
3. If the scan list status icon is blank ( ), the group/channel can be added to the scan list by pressing the
key. will be displayed on line three.
4. Press the key a second time to set the group/channel to Priority 2. is displayed on line three.
5. Press a third time to set the group to Priority 1. is displayed on line three. The priority level
section sequence only advances the group/channel to the next high priority level and stops at priority
level 1. To select a lower priority level, the group/channel must be deleted from the scan list and then
added back to the scan list. Each new group added to the scan list starts at the lowest priority. If the
Priority 1 and Priority 2 group/channel are already set and a new group is assigned as Priority 1 or
Priority 2, the previously assigned group/channel will change to non-priority scanning. One of the
following messages may be momentarily displayed:
The radio is not programmed to scan.
A Priority 1 group has been pre
-
programmed into the radio. A new Priority 1 group
cannot be selected.
A fixed scan list has been pre
-
programmed into the radio. It is not possible to change
the list without reprogramming the radio.
To quickly view multiple group scan status, press
then slowly rotate the group
knob. Each group status will appear on the display.
P7370 Model Radio
1. With scan operation turned OFF, select the desired group/channel to add to the selected scan list.
2. Press . The current priority status of the group/channel will be displayed in column 10 of line
three for a time-out period. If the group is not part of the scan list, the status will be blank.
3. While the status is displayed, press to add the group/channel to the scan list. The icon is
displayed on line three.
4. Press a second time to set the group to Priority 2. The icon is displayed on line three.
5. Press a third time to set the group/channel to Priority 1. The icon is displayed on line three.
The priority level selection sequence only advances the group/channel to next higher priority level
and stops at priority level 1. To select a lower priority level, the group/channel must be deleted from
the scan list and then added back to the scan list. Each new group/channel added to the scan list starts
at the lowest priority. If the Priority 1 and Priority 2 group/channel are already set and a new
To Next Page
Loading...
Need help?
General
