MM-013994-001, Rev. J
62
Figure 10-4: P7370 “System” Radio Front Panel
Table 10-3: P7370 Keypad Functions
KEY FUNCTION
Primary Function: Accesses the pre-stored menu.
Secondary Function: Activates a selected item within the menu. This is similar to an “Enter” key.
Primary Function: Allows the user to scroll through available systems, groups, or channels, depending on
personality programming.
Secondary Function: Changes the selection for an item within a list.
0-9,
and
Primary Function: Refer to the separate key definitions within this table.
Secondary Function: These keys function much as a typical DTMF telephone pad 0-9, *, and # keys; and
are used to place telephone interconnect and individual (unit-to-unit) calls.
Selects a specific system. If the rotary knob is used to select the system and more than 16 systems are
programmed in the radio, this key is used to select additional banks (groupings) of systems.
Selects a specific group.
Turns the Scan operation ON and OFF.
Enables or disables Private Mode for the system/group/channel displayed.
Adds groups or channels from the currently selected system to the Scan list.
Status. Access to the status list (0-9). The Status key permits the transmission of a pre-programmed status
message to an EDACS or P25 site.
Message. Access to the message list (0-9). The Message key permits the transmission of a pre-
programmed message to an EDACS or P25 site.
Deletes selected groups or channels of the currently selected system from the Scan list.
Inverts display – Toggle normal/invert.
Initiates telephone interconnect calls.
Initiates individual unit-to-unit calls.
To Next Page
Loading...
