MARK IV HD J2 TAMPER OPERATION PAGE 2.2 - 7
BULLETIN 5082505 JUPITER II REVISED 10 - 2020
2.2
2.2.1 Jupiter II Control System
2.2.1.3 Simplified Electrical System
1. The use of Jupiter II remote I/O devices helps simplify electrical systems through:
a. Reduction of wires and wire terminations.
b. Use of quick disconnect cables.
c. Shorter wire runs.
d. Only two primary module types.
e. Like module types and cables are interchangeable.
2.2.1.4 Improved Reliability
1. The rugged design of the Jupiter II modules improves the reliability of the electrical control
system. Jupiter II modules are built to operate at extreme temperatures of -40° C to
+70° C. All modules are IP67 rated (waterproof), CE labeled and fully potted for extreme
vibrations. Pre-molded cables and cord sets eliminate field wiring and reduce the
likelihood of open and/or short circuits. Each module provides a layer of electrical (and
logical) isolation from the rest of the system thereby containing problems and simplifying
repair. The increased capacity of output channels handles a wide range of load conditions.
2.2.1.5 Scalable Platform
1. The modular design of the Jupiter II Control System makes it possible to install Jupiter on
small machines as well as large complex machines. This feature will lead to a common
control system on an entire fleet of machines. The use of common control system
components that are interchangeable from machine to machine enables inventory
reduction, common schematics, reduced service technician training and a common set of
features and diagnostic tools between a wide variety of machines.
To Next Page