Harsco MARK IV - Panel Latch; Power Inverter - Monitor; Printer Option; Power Inverter - Radio Option; Satellite Radio Option

PAGE 2.1 - 34 OPERATION MARK IV HD J2 TAMPER
REVISED 10 - 2020 CONTROLS BULLETIN 5082505
2.1
2.1.6 Control Panel - Right - See Figures 2.1-29 and 2.1-30
The Right Control Panel is located ahead of and to the right of the operator’s seat. The Right
Control Panel houses the following controls:
(1) Panel Latch
Rotate the latch to open the panel to gain access to the inside of the Left Control Panel. The
inside of the compartment is empty and can be used to store the Operator’s Manual, Parts
Manual, etc.
(2) Power Inverter - Monitor / Printer Option
The power inverter is located below the Right Control Panel. The power inverter converts 24
volt DC electrical power to 120 volts AC / 60 hertz electrical power for the computer monitor and
printer.
(3) Power Inverter - Radio Option
The power inverter is located below the Right Control Panel. The power inverter converts 24
volt DC electrical power to 12 volt DC electrical power for a mobile radio supplied by the
customer.
(4) Satellite Radio Option
The satellite radio is located below the Right Control Panel. The satellite radio is used for
transmitting the machine location and information via satellite communication.