Harsco MARK IV - Controls; Locks Locations; Travel Locks Locations

PAGE 2.1 - 6 OPERATION MARK IV HD J2 TAMPER
REVISED 10 - 2020 CONTROLS BULLETIN 5082505
2.1
2.1.1 Controls / Locks Locations
Travel Locks Locations - See Figure 2.1-1
The MARK IV HD J2 Tamper has the following travel locks located in the general areas
illustrated on the machine:
(1) Workhead Lift - 1 Air Lock Pin Each Workhead - Controls In Cab
(2) Workhead Traverse - 1 Manual Lock Pin Each Workhead
(3) Traverse Extensions - 1 Manual Lock Pin Each Side
(4) Combo Clamp - 1 Air Lock Latch Each Side - Controls In Cab
(5) Shadowboard - Air Lift / Lock Controls
(6) Shadowboard - 1 Air Lock Latch Each Side
(7) Lining Light Shield - 1 Manual Lock Pin Each Side
(8) Lining Receiver - 1 Manual Lock Pin - Standard
Lining Receivers - 2 Manual Lock Pins - Dual Reference Option
(9) Receiver Buggy - Air Lift / Lock Controls
(10) Receiver Buggy - 1 Air Lock Latch
(11) Buggy Lift - Hydraulic Lift / Air Lock Controls
(12) Buggy Lift - 1 Manual Lock Pin
(13) Pusher Bars - 1 Spring Loaded Latch Cable
(14) Pusher Bars - 4 Air Lock Pins
(15) Projector Buggy - 1 Air Lock Pin
(16) Lining Projector - 1 Manual Lock Pin - Standard
Lining Projectors - 2 Manual Lock Pins - Dual Reference Option
(17) Telescoping Pole - 1 Manual Lock Pin
(18) Laser Alignment Cart Option - 2 Manual Locks Pins