Harsco MARK IV - Workhead Lock Key; Workhead Vibrator Key - Left Outer - Work Mode; Workhead Vibrator Key - Left Inner - Work Mode; Workhead Vibrator Key - Right Inner - Work Mode

MARK IV HD J2 TAMPER OPERATION PAGE 2.1 - 45
BULLETIN 5082505 CONTROLS REVISED 10 - 2020
2.1
2.1.9 Operator Keypad Controls - Left - See Figure 2.1-33
(13) Workhead Lock Key - Work Mode
Press and release the key to UNLOCK the left and right workhead locks. Press and release the
key again to LOCK the left and right workhead locks.
(14) Workhead Vibrator Key - Left Outer - Work Mode
(15) Workhead Vibrator Key - Left Inner - Work Mode
(16) Workhead Vibrator Key - Right Inner - Work Mode
(17) Workhead Vibrator Key - Right Outer - Work Mode
Press and release the applicable key to turn ON the applicable workhead vibrator motor. Press
and release the applicable key again to turn OFF the applicable workhead vibrator motor.
(18) Switch Mode Key - Work Mode
Press and release the key to enable the Switch Mode. Press and release the key again to
enable the Production Mode. See Jupiter II Operation - Switch Mode Panel.
(19) Auto Tamp Key - Work Mode
Press and release the key to turn ON the Auto Tamp feature. Press and release the key again to
turn OFF the Auto Tamp feature. See Jupiter II Operation - Auto Tamp Panel.
(20) Tie Finder Key Option - Work Mode
Press and release the key to turn ON the AutoMag Tie Finder Option sensor probes (or
antennas). Press and release the key again to turn OFF the AutoMag Tie Finder Option sensor
probes (or antennas). See Jupiter II Operation - Tie Finder Panel.