PAGE 2.1 - 22 OPERATION MARK IV HD J2 TAMPER
REVISED 10 - 2020 CONTROLS BULLETIN 5082505
2.1
2.1.2 Controls - Exterior
(37) Emergency Towing Couplers Option - Being Towed - See Figure 2.1-20
(38) Emergency Towing Couplers Option - When Towing - See Figure 2.1-20
The Emergency Air Couplers are located on both the front and rear ends of the machine.
a. The Being Towed Couplers can be used to connect auxiliary air lines from the towing
machine to the Tamper to release and operate the brake actuators on the Tamper
when being towed.
b. The When Towing Couplers can be used to connect auxiliary air lines from the
Tamper to the machine being towed to release and operate the brake actuators on
the machine being towed.
(39) Tow Bar Option - See Figure 2.1-21
The Tow Bar Option is located on the left side of the machine next to the engine. The tow bar
can be installed and secured to the machine frame using the draw bar pins (A) or removed from
the machine frame to tow the machine or another machine.
To Next Page
Loading...