Processing Mail
38
3
Re-dating Mail
Sequence of Settings
The procedure below outlines steps to re-date mail that has already been processed.
The sequence is similar to sequence
Applying Standard Postage
(p.33 ), except for
the following settings:
• Postage must be set to zero and have the date of mailing correct
• You do not have to weigh the mail piece.
• Print the new date on the back or bottom of the front of the envelope.
How to Re-Date Mail (Settings)
How to Re-Date
Mail (Settings)
Required settings:
1 Make sure you are on the home screen of the [Standard ]
type of imprint . The home screen indicates weight, postage
and currently selected rate as illustrated below.
2 ²Check or change the type of imprint .
Press and type
1 to access the
Customize stamp
screen:
The type of imprint is indicated on line 2 of the screen.
To change the type of imprint , select the
Type
line, press
[OK] and then select [Normal ] in the
Type of imprint
screen
and press [OK] .
Make sure you have already completed the preparation steps
mentioned in
Preparing and Starting your Work Session
p.27 .
To select an option in the screen:
Highlight the option using the arrow keys and
Then press to validate your selection.
ALPHA1_US.book Page 38 Mardi, 3. mai 2011 2:23 14
To Next Page
Loading...
