204 Back boring îš„
205 Universal pecking îš„
206 Tapping with a floating tap holder, new îš„
207 Rigid tapping, new îš„
208 Bore milling îš„
209 Tapping with chip breaking îš„
220 Circular point pattern îš„
221 Linear point pattern îš„
230 Multipass milling îš„
231 Ruled surface îš„
232 Face milling îš„
240 Centering îš„
241 Single-fluted deep-hole drilling îš„
247 Datum setting îš„
251 Rectangular pocket (complete machining) îš„
252 Circular pocket (complete machining) îš„
253 Slot milling îš„
254 Circular slot îš„
256 Rectangular stud (complete machining) îš„
257 Circular stud (complete machining) îš„
262 Thread milling îš„
263 Thread milling/countersinking îš„
264 Thread drilling/milling îš„
265 Helical thread drilling/milling îš„
267 Outside thread milling îš„
270 Contour train data îš„
275 Trochoidal slot îš„
Cycle
number
Cycle designation
DEF
active
CALL
active
To Next Page
Loading...
Need help?
General
