M109
M110
M111
Constant contouring speed at tool cutting edge
(increase and decrease feed rate)
Constant contouring speed at tool cutting edge
(feed rate decrease only)
Reset M109/M110
îš„
îš„
îš„
Page 314
M114
M115
Automatic compensation of machine geometry when working with tilted axes
Reset M114
îš„
îš„
Page 409
M116
M117
Feed rate for rotary axes in mm/min
Reset M116
îš„
îš„
Page 406
M118 Superimpose handwheel positioning during program run îš„ Page 317
M120 Pre-calculate radius-compensated contour (LOOK AHEAD) îš„ Page 315
M124 Do not include points when executing non-compensated line blocks îš„ Page 308
M126
M127
Shortest-path traverse of rotary axes
Reset M126
îš„
îš„
Page 407
M128
M129
Retain position of tool tip when positioning tilting axes (TCPM)
Reset M128
îš„
îš„
Page 410
M130 Moving to position in an untilted coordinate system with a tilted working plane îš„ Page 306
M134
M135
Exact stop at nontangential contour transitions when positioning with rotary axes
Reset M134
îš„
îš„
Page 413
M136
M137
Feed rate F in millimeters per spindle revolution
Reset M136
îš„
îš„
Page 313
M138 Selection of tilted axes îš„ Page 413
M140 Retraction from the contour in the tool-axis direction îš„ Page 318
M141 Suppress touch probe monitoring îš„ Page 319
M142 Delete modal program information îš„ Page 320
M143 Delete basic rotation îš„ Page 320
M144
M145
Compensating the machine’s kinematics configuration for ACTUAL/NOMINAL positions at
end of block
Reset M144
îš„
îš„
Page 414
M148
M149
Retract the tool automatically from the contour at NC stop
Reset M148
îš„
îš„
Page 321
M150 Suppress limit switch message (function effective blockwise) îš„ Page 322
M200
M201
M202
M203
M204
Laser cutting: Output programmed voltage directly
Laser cutting: Output of voltage as a function of distance
Laser cutting: Output of voltage as a function of speed
Laser cutting: Output of voltage as a function of time (ramp)
Laser cutting: Output voltage as a function of time (pulse)
îš„
îš„
îš„
îš„
îš„
Page 323
M Effect Effective at block... Start End Page
To Next Page
Loading...
Need help?
General
