HEIDENHAIN iTNC 530 95
3.2 Creating and Writing Programs
Inserting blocks at any desired location
U Select the block after which you want to insert a new block and
initiate the dialog.
Editing and inserting words
U Select a word in a block and overwrite it with the new one. The plain-
language dialog is available while the word is highlighted.
U To accept the change, press the END key.
If you want to insert a word, press the horizontal arrow key repeatedly
until the desired dialog appears. You can then enter the desired value.
Function Soft key/Key
Set the selected word to zero.
Erase an incorrect number.
Clear a (non-blinking) error message.
Delete the selected word.
Delete the selected block.
Erase cycles and program sections.
Insert the block that you last edited or
deleted.
To Next Page
Loading...
