6 System settings and service software
CargoPower installation and operation, revision - 01 55
6.1.6.2 "Display" tab
• Select the display installed in the system under "Display type".
For each support level, the maximum power provided by the motor can be set here.
The information is given in %.
There are differences depending on whether a torque or speed sensor is installed.
If a speed sensor is installed, the maximum assistance to be set is 100% and refers
to the maximum motor power.
Example: "Support level 1" >> set value 20%.
The motor then supports with 20% of its maximum power when this level is
selected.
If a torque sensor is installed, the value is adjustable up to 1600% and refers to the
torque applied by the driver.
Example: "Support level 1" >> set value 800%.
The motor then assists with an additional 800% of the torque contributed by the
driver when this level is selected.
6.1.6.3 "Battery" tab
• Select the battery installed in the system.
6.1.6.4 "Sensors" tab
• Select the bottom bracket sensor installed in the system at
"Torque/Speed Sensor Type".
• In addition, the upper and lower reference voltage of the installed throttle grip can
be adjusted and the current voltage can be read out.
To Next Page