HellermannTyton Autotool 2000 CPK - Page 32

Operating Instructions • AT2000 CPK • 07-2019 • v03 • 106-29004
Troubleshooting
32
DISPLAY MESSAGE POSSIBLE CAUSE SOLUTION
1. Operate bandoleer cutter
2. Open gate
Error, drum
• The cable tie bandoleer is
pulled in at an angle.
• Roller lever drum is jammed
or is defective.
f Push actuator for bandoleer cutter to the left.
f Open the gate.
f Open the two transparent service flaps at the gate,
à"Troubleshooting a cable-tie bandoleer
malfunction" on page33.
; Error, drum appears as the next message on the
display.
1. Remove cable-tie residues
2. Press Reset button
Error, drum
f If applicable, carefully remove the cable-tie residues.
f Open the roller lever drum and turn the drum to the
correct position.
f Press the Reset button.
; Error, gate appears as the next message on the
display.
f Close the gate.
f Load a new cable tie bandoleer, à"Loading cable
ties" on page11.
1. Operate bandoleer cutter
2. Open gate
Overload
• The drum is blocked.
• The bandoleer cutter does
not cut off the cable ties.
• The cable tie bandoleer is
pulled in at an angle.
f Push actuator for bandoleer cutter to the left.
f Open the gate.
f Open the two service flaps at the gate,
à"Troubleshooting a cable-tie bandoleer
malfunction" on page33.
; Error, overload appears as the next message on
the display.
1. Remove cable-tie residues
2. Press Reset button
Overload
f If applicable, carefully remove the cable-tie residues.
f Press the Reset button.
; Error, gate appears as the next message on the
display.
f Close the gate.
1. Operate bandoleer cutter
2. Open gate
Error, tensioning motor
• Drive is jammed or is
defective.
f Push actuator for bandoleer cutter to the left.
f Open the gate.
f If applicable, carefully remove the cable-tie residues.
f Press the Reset button.
; Error, gate appears as the next message on the
display.
f Close the gate.
1. Check binding
2. Confirm with trigger
Error, binding force
• The specified binding force
is not achieved.
The message appears only if
error notification is activated,
à"Check of binding" on
page16.
f Check the binding.
f If applicable, reset the binding force.
f If applicable, carefully remove the cable-tie residues.
f Press the trigger as confirmation.