HIKVISION DS-2SF8C442MXG-EL/26 - Page 35

What to do next
Set the linkage and alarm. See ITS Linkage and Alarm for details.
Set Illegal Parking Evidence Capture Parameters
Go to VCA → Intell Trac Event → Advanced Conguraon → Advanced to set the parameters.
Illegal Parking LPR Area
Set the size of license plate recognion area that suits the actual situaon to avoid mistakenly
recognize the license plate of other vehicles around.
Illegal Parking LPR Double Check
The device double-checks the license plate to avoid mistakenly capturing of other vehicles.
Illegal Parking LPR Grading Threshold
If the condence level of captured license plate or any character on the license plate is lower
than the threshold, the plate will not be recognized. The alarm
informaon may be ltered out
if the threshold is too high.
Illegal Parking Plate Size Threshold
If the width of the captured license plate is lower than the set threshold, the plate will not be
recognized. The lower the threshold is, the smaller plates will be ltered out. It is recommended
to keep the default value.
Illegal Parking Target Lock
When the illegal parking target lock is enabled, the device focuses on the vehicle that triggers
the evidence capture and ignores other vehicles. It is suitable for
situaons where strict
enforcement is required, but it decreases the overall evidence capture
eciency.
Set Reverse Driving
Detecon
Reverse driving refers to driving against the direcon of trac. The device detects violaons and
captures evidence pictures.
Before You Start
Set
detecon scenes and detecon areas. See Set Detecon Scene and Set Lane Area for details.
Steps
1.
Go to VCA → Intell Trac Event → Common Sengs → Speed Dome Rule Sengs .
2.
Select Enforcement.
3.
Click Reverse Driving
Detecon and check Enable.
4.
Select Arm Lane.
Note
The direcon of the arm lane cannot be Unknown.
TandemVu PTZ Camera User Manual
23