HIKVISION DS-2SF8C442MXG-EL/26 - Page 36

Reverse driving detecon takes eect in the selected lane areas.
5.
Set the Amount of Pictures.
The device takes evidence pictures of the set amount when a vehicle hits the trigger line in the
detecon area.
6.
Set
Sensivity.
With higher
sensivity, the device is more sensive to detect and recognize targets.
7.
Click Save.
What to do next
Set the arming schedule, linkage and alarm. See
Set ITS Arming Schedule and ITS Linkage and
Alarm for details.
Set U-turning
Detecon
The device detects vehicles making a u-turn where it is not allowed and captures evidence
pictures.
Before You Start
Set detecon scenes and detecon areas. See Set Detecon Scene and Set Lane Area for details.
Steps
1.
Go to VCA → Intell Trac Event → Common Sengs → Speed Dome Rule Sengs .
2.
Select Enforcement.
3.
Click U-turning
Detecon and check Enable.
4.
Select at least two lanes in Arm Lane.
Note
The direcon of the arm lanes cannot be the same and the lane lines between the two lanes
cannot be Broken Line. Otherwise, the u-turning event will not be triggered.
U-turning detecon takes eect in the selected lane areas.
5.
Set
Sensivity.
With higher sensivity, the device is more sensive to detect and recognize targets.
6.
Click Save.
What to do next
Set the arming schedule, linkage and alarm. See
Set ITS Arming Schedule and ITS Linkage and
Alarm for details.
Set Over Lane Line
Detecon
The device detects vehicles driving over lane lines where it is not allowed and captures evidence
pictures.
TandemVu PTZ Camera User Manual
24