System Manual Compact Systems Table of Contents
HI 800 141 E Rev. 2.02 Page 5 of 110
7.1.1.1 Definitions 44
7.1.1.2 Installation Type 44
7.1.1.3 Natural Convection 45
7.2 Installation and Mounting 45
7.2.1 Mounting 46
7.2.1.1 Routing Cables 47
7.2.2 Air Circulation 48
7.2.3 Construction Depths 49
7.2.4 Connecting the Input and Output Circuits 50
7.2.5 Earthing and Shielding 50
7.2.5.1 Earthing the 24 VDC System Voltage 50
7.2.5.2 Earthing Connections 51
7.2.5.3 Shielding 51
7.2.5.4 EMC Protection 51
7.2.6 Connecting the Supply Voltage 51
7.3 Configuration with SILworX - CPU OS V7 and Higher 52
7.3.1 Configuring the Resource 52
7.3.1.1 Resource Properties 52
7.3.1.2 Parameters for the Remote I/Os 55
7.3.1.3 Hardware System Variables for Setting the Parameters 56
7.3.1.4 Hardware System Variables for Reading the Parameters 56
7.3.1.5 Rack System Parameter Settings 59
7.3.2 Configuring the Ethernet Interfaces 59
7.3.3 Configuring the User Program 60
7.3.4 Configuring the Inputs and Outputs 61
7.3.5 Configure Line Control 63
7.3.5.1 Required Variables 63
7.3.5.2 Configuring Pulsed Outputs 64
7.3.5.3 Configuration Example with SILworX 64
7.3.6 Generating the Resource Configuration 65
7.3.7 Configuring the System ID and the Connection Parameters 66
7.3.8 Loading a Resource Configuration after a Reset 66
7.3.9 Loading a Resource Configuration from the PADT 67
7.3.10 Loading a Resource Configuration from the Flash Memory of the Communication
System 67
7.3.11 Cleaning up a Resource Configuration in the Flash Memory of the Communication
System 67
7.3.12 Setting the Date and the Time 68
7.4 User Management in SILworX - CPU OS V7 and Higher 68
7.4.1 User Management for SILworX Projects 68
7.4.2 User Management for the Controller 69
7.4.3 Setting up User Accounts 70
7.5 Configuration with SILworX - CPU OS V7 and Higher 71
7.5.1 Configuring the Ethernet Interfaces 71
7.6 Configuring Alarms and Events in F*03 Devices 72
7.7 Configuring a Resource Using ELOP II Factory - CPU OS up to V7 75
7.7.1 Configuring the Resource 75
7.7.2 Configuring the User Program 76
7.7.3 Configuring the Inputs and Outputs 78
7.7.4 Configure Line Control 78
7.7.4.1 Required Signals 78
To Next Page
Loading...
Need help?
General
