Hioki 3455 - Clearing Indications of Temperature and Humidity Stored Data

6.3 Entering Temperature and Humidity Measured with
External Thermometer and Hygrometer
1
2
3
4
5
6
7
8
9
10
11
付録
索引
133
6.3.2 Clearing Indications of Temperature
and Humidity Stored Data
To turn off the indicator and
clear stored temperature and humidity data,
follow the procedure below.
Procedure
1. If a temperature sensor is connected to
the tester, disconnect the sensor.
2. Press the key while in the
standby state.
The temperature will blink.
3. Press the key.
The temperature is indicated as [ - - -
°C].
4. Press the key.
The humidity indicator will blink.
5. Press the key.
The humidity is indicated as [ - - - %RH]
6. Press the key.
This procedure only clears the indications on the
screen and does not delete the temperature and
humidity data stored in the memory.
 Delete data See 5.3 "Deleting Recorded Data"
(page 120).