Hioki 3455 - 2 Measurement Preparations; 2.1 Supplying Power

2.1 Supplying Power
1
2
3
4
5
6
7
8
9
10
11
付録
索引
31
This tester may be powered by several
means.
• LR6 alkaline battery
 See 2.1.1 "Installing or Replacing the Battery"
(page 31).
• 9459 BATTERY PACK (Option)
 See 2.1.2 "Installing the Battery Pack
(Rechargeable nickel-hydrogen battery)" (page
34), and 2.1.4 "Charging the Battery Pack" (page
41)
• 9753 AC ADAPTER (Option)
 See 2.1.3 "Connecting the AC Adapter" (page
39).
2.1.1 Installing or Replacing the Battery
Measurement
Preparations
2
2.1 Supplying Power
• To avoid electric shock, turn off the
power switch and disconnect the test
leads before replacing the batteries.
• Do not mix old and new batteries, or dif-
ferent types of batteries. Also, be care-
ful to observe battery polarity during
installation. Otherwise, poor perfor-
mance or damage from battery leakage
could result.
• After replacing the batteries, replace the
battery cover and screws before using
the instrument.
• Battery may explode if mistreated. Do
not short-circuit, recharge, disassemble
or dispose of in fire.
• Handle and dispose of batteries in
accordance with local regulations.