Hioki 3455 - Performing Temperature Correction

4.3 Temperature Correction (TC)
88
4.3.1 Performing Temperature Correction
Procedure
1. Measure temperature and insulation
resistance. The measurements are held
upon completion.
(Either may be measured first.)
 3.2 "Measuring Insulation Resistance" (page 56)
See 3.4 "Measuring Temperature" (page 76).
The temperature may also be entered with
keys.
 See 6.3 "Entering Temperature and Humidity
Measured with External Thermometer and
Hygrometer" (page 129).
In the step voltage test mode ([STEP] is on),
temperature correction is unavailable. Exit
the step voltage test mode.
 See 4.4.3 "Exiting Step Voltage Test Mode"
(page 99).
2. Press the key.
[TABLE No.] blinks.
3. Choose a table No. from 0 to 9 using the
key.