2.2 Turning Power On and Off
1
2
3
4
5
6
7
8
9
10
11
付録
索引
45
2.2.1 Auto Power Off
• Power is automatically turned off around
10 minutes after the last operation. This
function, however, is not available during
insulation resistance measurement.
•[
APS] will start blinking around 30 sec-
onds before power is turned off.
• Auto power off is re-enabled upon turning
power on again. ([
APS] lights up.)
• When the AC adapter is connected to the
tester, auto power off is disabled.
• When the timer is set or when the tester is
in the step voltage test mode, auto power
off is disabled.
Turn on power while holding down the
key.
Canceling Auto Power Off
To Next Page
Loading...
