Hioki 3455 - 4 Advanced Measurement; Using Timer; Setting Timer;Conducting Insulation Resistance Measurement

4.1 Using Timer
1
2
3
4
5
6
7
8
9
10
11
付録
索引
79
If the timer is set during insulation resis-
tance measurement, the measurement
automatically ends at the set time.
Selectable time: 30 sec. to 30 min. (When
setting over 1 minute, time increments or
decrements in minutes.)
4.1.1 Setting Timer/Conducting Insulation
Resistance Measurement
Procedure
1. When the tester is in a standby state,
press the key.
The time indication will blink.
2. Press the key to set the time.
Advanced
Measurement
4
4.1 Using Timer
What is it used for?
Used to set the tester to automati-
cally stop at a specified time.