Hioki RM3544-01 - Appendix 18 Instrument Settings (Memo)

Appendix 18 Instrument Settings (Memo)
A37
Appendix
When you return your instrument to be calibrated or repaired, its settings will be reset to
their default values. It is recommended to make note of the instrument's settings using the
following table before sending it to be calibrated or repaired
*1: RM3544-01 only
Appendix 18 Instrument Settings (Memo)
Screen Setting and Key Setting
Measurement screen COMP
AUTO
 (RANGE)
SPEED
Measurement screen
(P.1/2)
VIEW (F2)
Measurement screen
(P.2/2)
0 ADJ (F1)
LOCK (F2)
Setting
screen
(SETTING)
Measurement
Settings screen
(MEAS)
TC SET
AVERAGE
AUTO HOLD
COMP DELAY
SCALING(A∗R+B)
A:
B:
UNIT:
 DIGITS
CURR ERROR MODE
System
Settings screen
(SYS)
KEY CLICK
COMP BEEP Hi
IN
Lo
PANEL LOAD 0ADJ
0ADJ RANGE
CONTRAST
BACKLIGHT
POWER FREQ
EXT I/O
Settings screen
(I/O)
*1
TRIG SOURCE
TRIG EDGE
TRIG/PRINT FILT
EOM MODE
JUDGE/BCD MODE
Communica-
tions Interface
Settings screen
(IF)
*1
INTERFACE
SPEED
DATA OUT
CMD MONITOR
PRINT INTRVL
PRINT COLUMN