Hioki RM3544-01 - Chapter 2 Measurement Preparations; 2.1 Connecting the Power Cord

2.1 Connecting the Power Cord
25
2
Be sure to read the "Operating Precautions" (p.5) before installing and connecting this
instrument.
Refer to "Appendix 14 Rack Mounting" (p. A28) for rack mounting.
Turn off the power before disconnecting the power cord.
Measurement
Preparations
Chapter 2
2.1 Connecting the Power Cord
Rear Panel
1 Confirm that the instrument's Main power
switch (rear panel) is OFF( ).
2 Confirm that the mains supply voltage matches
the instrument, and connect the power cord to
the power inlet on the instrument.
3 Plug the power cord into the mains outlet.
If power to the instrument is cut off with the power switch
in the ON position (by a circuit breaker, etc.), the instru-
ment will start up when power is restored, without any
need to press the STANDBY key.
Power inlet
Main power switch