Wireless LAN – WLAN
76
3.4
Configuration of WLAN parameters
BAT54-Rail/F..
Release
7.54
06/08
Note: In addition to setting the client EAP method, also be sure to observe
the corresponding setting for the WLAN client operation mode!
The client EAP method setting has no function on logical WLAN networks
other than WLAN 1.
U Indoor function for WLAN channels
When selecting the frequency band (2.4 or 5 GHz), among other things, you
must determine the channels which may possibly be used for transmission.
From these possible channels, under automatic channel selection, a
Wireless Router selects a free channel, for example, in order to avoid inter-
ference with other radio signals.
In some countries, there are special regulations on the frequency bands and
channels which may be used for WLAN for indoor and outdoor operation. For
example, in France, not all available channels in the 2.4 GHz band may be
used in outdoor operation. In some countries the DFS procedure is required
for outdoor operation in the 5 GHz band in order to avoid interference from
radar systems.
With the option 'indoor-only' a BAT Wireless Router can be restricted exclu-
sively to operation in closed buildings. This restriction on the other hand al-
lows the channels to be managed more flexibly under automatic channel
selection.
D Indoor-only [default: off]
D In the 5 GHz band in ETSI countries, the channel selection is limited
to the channels 36, 40, 44 and 48 in the frequency range 5.15 to
Configuration tool Call
LANconfig WLAN interfaces
 General
WEBconfig, Telnet Expert configuration > Setup > WLAN
To Next Page
Loading...
Need help?
General
