Hitachi Compute Blade 2500 - Specifications of the Power Supply Module

Item Specifications
Security • Management access ACLs
• IEEE 802.1x port-based authentication
• Radius and TACACS+
Operability, management functionality,
and monitoring functionality
• Simple Network Management Protocol
(SNMP v1/v2/v3)
• Telnet interface for CLI
• SSH and SSH v2 for CLI
• Serial interface for CLI
• POST diagnostics
Supported standards • IEEE 802.1AB Data Center Bridging
Capability Exchange Protocol (DCBX)
• IEEE 802.1p Class of Service (CoS)
prioritization
• IEEE 802.1Q Tagged VLAN (frame tagging
on all ports when VLANs are enabled)
• IEEE 802.1Qbb Priority-Based Flow Control
(PFC)
• IEEE 802.1Qaz Enhanced Transmission
Selection (ETS)
• IEEE 802.3 Ethernet
• IEEE 802.3ab 1000BASE-T copper twisted
pair Gigabit Ethernet
• IEEE 802.3ad Link Aggregation Control
Protocol
• IEEE 802.3ae 10GBASE-SR short range
fiber optics 10 Gb Ethernet
• IEEE 802.3ap 10GBASE-KR backplane 10
Gb Ethernet
• IEEE 802.3ba 40GBASE-SR4 short range
fiber optics 40 Gb Ethernet
• IEEE 802.3x Full-duplex Flow Control
External dimensions (width x depth x
height)
401 mm x 317 mm x 30 mm
Weight 3.58 kg
Note:
1. You can use 24 ports (total number of 10 Gbps internal and external ports) in the
initial settings (the settings at shipping time).
2. Using this port requires a dedicated serial management cable.
Specifications of the power supply module
The following table shows the specifications of the power supply module.
A-16
System Unit Specifications
Hitachi Compute Blade 2500 Series Getting Started Guide