To reset the default password for the switch, use the terminal software to
access the management functionality of the Brocade 10Gb DCB switch
module.
Logging in to the switch module
1. From the system console, open the terminal software.
2. In the terminal software, specify the IP address of the desired switch
module and connect to the switch module.
You use telnet or SSH (version2) for a connection protocol by default.
3. From the terminal software, access the management functionality of the
switch module.
4. When the terminal software displays the prompt login: type admin and
press Enter.
The following response is displayed:
Password:
5. Type password and press Enter.
You are now successfully logged in.
Changing the password of the "admin" account
To ensure security, change the login password of the "admin" account from
the initial settings (the settings at shipping time).
To do this, you must be connected and logged in to the switch module using
the "admin" account via the terminal software.
1. At the prompt of the terminal software, type configure terminal and
press Enter.
The mode is changed to the global configuration mode.
2. Type username admin password ******** role admin enable true
and press Enter.
The string ******** represents the new password. Enter a string of your
choice.
When the confirmation is displayed, the setting of the password is
complete.
Logging out from the switch module
At the prompt of the terminal software, type exit and press Enter.
Connecting the system console and the system unit to the
management LAN
After you have finished configuring the network settings within the system
unit so that it can connect to the external management LAN, connect the
system unit and the system console to the management LAN. Once they are
connected, you can manage the system unit remotely via the management
LAN network.
3-10
Starting the CB 2500 and Performing Initial Setup
Hitachi Compute Blade 2500 Series Getting Started Guide
To Next Page
Loading...
Need help?
General